STEPS TO BE FOLLOWED FOR LOADING SOTFWARE IN PLC SYSTEM:ġ0. COMMUNICATION CABLES 2NOS(RS232C TO RS422 CONVERTER CABLE & CABLE WITH RS232C FEMALE CONNECTOR AT BOTH THE ENDS) PLEASE ENSURE THAT FOLLOWING TOOLS ARE AVAILABLE READLYĤ. PROCEDURE FOR SOFTWARE UPDATION USING LAPTOP OR COMPUTER:ġ. MITSUBISHI PLC AND DISPLAY PROGRAMMING DETAILS: If there is a chip installed in the eeprom slot I would remove it and If that is the case it will overide any program that you are trying to load. If there is a chip installed in the eeprom slot it may be a one time prom chip that can not be programmed more than once. The only software I had at the time was the oldĭOS based MEDOC software and a demo Windows version that would let me program the FX series but not allow eeprom transfers. If memory serves me I could only transfer a program to the eeprom through a hand held programmer. I have a FX-EEPROM-8 in my hand and it indeed has a protect switch. OOPS! I think in addition to the s/s terminal there is also a run terminal. I agree with Goody, try the battery thing.Īlso I have not used the Melsec SWOPC-FXGP/Win-E v3.0 software. The "run" is enabled through the s/s(start/stop) terminals on the plc. There is no "protect switch" or "run switch" on the "FX" series plc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |